Legionellosis and other infectious diseases caused by bad water hygiene management can lead to a detrimental and sometimes fatal outcome. These diseases are statutorily notifiable in Ireland under the infectious Diseases regulations 2011. Causes of outbreaks should be notified to the Department of public health.
Tips and Recommendations
✔ Carry out a Risk assessment for the workplace which should identify any risks and hazards.
✔ All facilities should have a water safety plan.
✔ An up to date schematics of the water distribution system.
✔ Steps to avoid stagnant water /Biofilm.
✔ Timed or Temperature Flushing system - Underused water outlets such as sinks ,showers, toilets and Emergency Eye wash /shower stations particularly end of line are big risk areas.
✔ Water temperature is vital . Keep hot water hot and cold water cold .
✔ Keep hot water stored and circulating above 60 degrees /c and return pipe not below 55 degree /c
✔ Cold water should be kept below 20 degrees/c
✔ Pressure and flow must be maintained and monitored throughout the distribution system .
✔ Intelligent water management systems and automated flushing regimens with Temperature control and record keeping should be considered .
✔ Materials ,fixtures and fittings that support Biofilm and micro-oranism growth and colonisation should be avoided.
For more Information on Water Hygiene systems see our range of Kemper Hygiene systems or you can click on the image above to view/download the brochure .Our utilities Department would be happy to survey your site and advise on your requirements against Water Infection prevention.
CPD training and certification available on request. Contact any member of the Utilities department at Hanley Controls Clonmel ltd
Stewart-Buchanan High Tolerance NPT Thread goes over and above the normal tolerances of a standard NPT thread. Using current tapered thread standards, Stewarts have maximised the tolerance on the male thread while minimising the tolerance at the female end. This means that the NPT connection has five to six threads engaged when fully tightened compared with the usual three to four threads of a standard NPT connection.
For more information contact Dwayne Dunphy in the Mechanical Department on 052-6122722 or email email@example.com
Hanley Controls are delighted to present our new Metering and Services brochure. For more information contact Paul Fahy in the Metering and Services Dept on 052-6122722 or email firstname.lastname@example.org
Welcome to the news feed of Hanley Controls Clonmel Ltd. Find out about new products, news, events, offers and more.